วิธีการต่อ Wideband Air Fuel Ratio meter Output to FconVPro
หน้า 1 จาก 1
วิธีการต่อ Wideband Air Fuel Ratio meter Output to FconVPro
Sensor: Wideband O2 controller / AFR
To configure AFR Feedback or Auto Tune
Connect Air Fuel Ratio Meter output signal to pin 16 and ground to pin 5
• Set Ignition GCC Input: A/F
• Set AFR Feedback Map: Fuel Trim Map.
• Set AFR Feedback Water Temp Low: 70 C
• Set AFR Feedback Water Temp High: 110 C
• Set AFR 32x32 Map for Air Fuel Ratio Target
• Set AFR 32x32 Mask from 0 to 1 in any required cell.
• Perform cell-based dyno tuning.
To configure AFR Feedback or Auto Tune
Connect Air Fuel Ratio Meter output signal to pin 16 and ground to pin 5
• Set Ignition GCC Input: A/F
• Set AFR Feedback Map: Fuel Trim Map.
• Set AFR Feedback Water Temp Low: 70 C
• Set AFR Feedback Water Temp High: 110 C
• Set AFR 32x32 Map for Air Fuel Ratio Target
• Set AFR 32x32 Mask from 0 to 1 in any required cell.
• Perform cell-based dyno tuning.
pom_vr2- Junior
- จำนวนข้อความ : 48
Join date : 02/01/2010
ที่อยู่ : BKK,Thailand
Similar topics
» ขาย , สั่งซื้อ Air Fuel Ratio Meter AFX Powerdex
» การเลือกซื้อ Air Fuel Ratio Meter และ Knock Monitor พิจารณายังไงครับ
» การเลือกซื้อ Air Fuel Ratio Meter และ Knock Monitor พิจารณายังไงครับ
หน้า 1 จาก 1
Permissions in this forum:
คุณไม่สามารถพิมพ์ตอบ
|
|